Control eight servos via computer (or integrate them into your current control system.) The RZ SSC allows you to control up to eight hobby servos using either a computer, or from a microcontroller. Perfect for running automated routines in robots or animatronics. Smooth sequential action due to a proprietary method of stepping each servo from a start point to an end point before moving on to the next servo, the RZ SSC is much smoother than other sequential servo controllers. The RZ SSC software was written specifically to take advantage of this stepping method in order to produce a smooth motion from start to finish. Many servo controllers attach the connectors directly to the board making the board much larger than necessary. We have moved all of the bulky connectors from the board to the end of connecting wires. The 9V power supply lead and the serial connectors are pushed away from the board for mounting in more convenient locations elsewhere on your robot. The RZ SSC can be mounted to any flat surface on your robot with a mere 7/8” clearance and less than 1.5” square surface area using four 4-40 screws. An extra servo plug has been mounted on the RZ SSC so that you can power the servos separately from the controller board and the rest of your robot. Simple to install and use, RZ SSC software will run on any Windows based PC with a serial port. Programming your own software for the RZ SSC board is as simple as writing software for any other servo controller board available. It uses a PC's serial port or one micro controller I/O pin and accepts 3 bytes of data per command. Includes: RZ SSC controller, CD Rom software, Programming Cable, and Instructions. 1 Each |
Copyright © 2003-2008 E-Clec-Tech. All rights reserved. All other materials and logos are copyrighted by their respective owners, or companies. |