Monster Panning I

Using the same principle as a gearbox motor, the Monster Panning I increases the output of a standard size Hitec or Futaba servo to five times the original torque!

It also DECREASES the speed of the servo BY 5 times!

The Servo Gearbox can put out an incredible amount of torque.

This means that the body of the gearbox must be able to handle high vertical and horizontal loads.

The ź inch, high tensile ABS plastic plates are extremely rigid and durable and can be mounted in various positions.

The 1/4 inch output shaft is made of stainless steel and can handle many times the side-load of the original Hitec servo spline.

NOTE: For Hitec servos only. Includes gears for 5:1 ratio. Gearbox only; servo not included. Servo also requires modification.

Example (standard): With a 5:1 ratio and an HS-645MG servo, the Standard Servo Gearbox can lift up to 10 pounds using a 4" arm!

675+ in/oz of torque when used with the HS645MG servo! Over 2,000 in/oz of torque when used with the new HSR-5995TG servo!!

Medium scale is for the Hitec 700 series servos.

Example (quarter-scale): With a 5:1 ratio and a HS-805BB servo, the Quarter Scale Servo Gearbox can lift up to 30 pounds using a 4" arm!

1,715+ in/oz of torque when used with the HS805BB servo!

Note: Futuba spline is only available with the standard sized version.

Please choose your desired Servo Size, Servo Spline, & Gear Material, below.

1 Each